Seat Cupra R BAM 225

Description:

Cupra R BAM 225

Remapped stage 1 Revo,

Haven’t had chance to get it on a dyno,
But must be pushing minimum of 250bhp.

The Bam engine is the best you can get in a Cupra r.

Just carried out a oil change and filter. Cleaned the strainer also, which is sometimes known to block up, although it was clear.

Milltek full stainless exhaust,
Brembo front calipers (standard from factory). Just fitted genuine brembo pads. Have a box of rear brembo to be fitted also
-Forge dump valve - non recirculating

-Has the rev limiter in first. (Not technically launch control i don't think, probably done this twice since owning because the bangs are loud!)

Previous owner had an engine rebuild around 20,000-30,000 miles ago. Sadly though the Insurance lost the paperwork.

Was a Cat C. front engine leg was bent and bumper had a chunk out. This was repaired by a friend and I think it could be done better. I wouldn't say it has had any effect on the car. Still pulls like a train and handles well. But I am no expert, more than welcome to request images etc.
- Have decent second hand bumper (ready to go on. )
- Have front badge to go on
- Have new fog surrounds. + an extra pair of fog lights (on unfitted bumper)
- Have a high flow miltek sports cat (ready to be fitted)
MOT till -> 18 September 2021



I'm in no rush to get rid, I will just fix it up better.

Purely just testing the water.

Any further questions please contact me.