Fully built bmw e46 330ci 500bhp

Description:

BMW 330ci E46 build: fresh 12 months mot
Engine:
New piston rings gapped to .6
Crank has been balanced
Billet oil pump
Oil pump chain tensioner
ACL bottom end bearings (big and small end)
12mm headstuds
Hopwood 1.8mm decompression Headgasket
Turbo drain fitting fitted to side of timing cover
New timing chain and guides
New upgraded water pump
New power steering pump pulley
New alternator
Polished cams
Rebuilt vanos unit
New oil pressure switch, both cam sensors, new crank position sensor.
AN12 cam cover breather fitting
Power ride oil filter housing cover to run an Oil cooler which sits perfectly above the intercooler
Also has 2 m10x1 sensor inputs which are currently not used but there as easy parameter inputs.
Cold side:
Billet inlet manifold
Porsche 90mm throttle body
CCV delete
ICV delete
Ali welding on TB to allow for boost pipes.
Disa delete with map sensor conversion running Bosch map sensor
Full 76mm boost pipes with large intercooler.
Hot side:
Hopwood motorsport turbo manifold
Pulsar GTX3582R with turbo guard mesh cover
Hopwood turbo feed line
Custom turbo drain
50mm Hopwood wastegate
Full custom DZ Fabrication fab work.
3” full custom exhaust, downpipes consists of silly amounts of pie cuts. Really good work.
Screamer pipe facing down (car sounds amazing)
Custom heat shield to protect valve cover
Fueling:
Sytec motorsport fuel pressure regulator
630cc short Siemens deka injectors
Custom fuel rail
Walbro 450lph fuel pump
Sytec motorsport in-line fuel filter
Gearbox
Running an e36 m3 5 speed box.
Ceramic clutch with billet solid flywheel.
Clutch delay valve removed.
Chassis mounted Short shifter
Fresh Oil In the gearbox.
The car itself is still factory leather, electric memory seats.
330d rear end, diff, driveshafts and prop.
subframe reinforcements have been done and is fully polybushed
Just had all new brake lines, fuel lines, callipers rebuilt and new brakes
4 new wheel bearings
Trailing arms etc polybushed
Front and rear Strut brace
Purple tag rack
New droplinks
New prop donut and uprated centre bearing.
New polybushed gearbox mounts
Oil change done approx every 1,000 miles to monitor oil and filter. Absolutely perfect. Engine was monitored on dyno to listen to bottom end and everything is perfect.
Made 460bhp with 76mm throttle body on with less air/fueling(print out) and now bigger throttle ect should be near of 500bhp will Chuck back on dyno if I get enough time.
May take a px but ideally after a cash sale, this car is an absolute animal and will leave nuggets in your trousers.
The rear arches are getting sprayed this week so will be in mint condition.
Collection Newton abbot or can arrange delivery.