View all pics (7)
|
Nissan s15 Spec r , forged Jdm
Location: Wales - Pant
Swap Value: £20.000+
Model:
Nissan 200SX
Year:
1999
Mileage:
135 miles
Private Individual
Description:
Nissan Silvia S15
Engine -
Forged SR20det straight cam
Eagle Rods
Wossner Forged Pistons
ACL Head Bolts
Full ACL Race Bearing/Shell replacement (Mains & Big Ends)
Head was Crack tested and skimmed
Block was 0.5mm over bored to match the pistons and also skimmed to ensure a good mate to the head
Crank Balanced and polished
HKS Step 1 256 Cams
Driftworks rocker arm stoppers
Greddy Ally Pullies for Power Steering, Alternator etc
Seimens deka injectors
Garage d fuel pump
r35 maf
Nistune Ecu mapped by MB
Hot side -
Owen Developments 2871R Turbo with a wide step ring, uprated heat shield and 53/71 Billet GTX compressor wheel with Tial .64 V band housing and M Spec Competition bearings running an external waste gate and achieves full boost at just over 3k RPM
SR20det Walton vband manifold
Turbosmart Comp Gate 40 External waste gate (also v band attachment) with atmospheric screamer running parallel to the down pipe with exit near the front wheel
Geo -
Adjustable arms everywhere front and rear
Kw Adjustable coilovers
Driftworks geomasters
Modded subframe and rack
Apexi boost controller set to 3 boost settings A. 300hp B. 350hp C. 420hp
Have dyno read out for this for proof
Deep dish swede steering wheel / quick release hub
Willwood hydro
OGURA Clutch ( this is a mega clutch )
4:1 ratio welded diff (3rd/4th gear drifts no problem)
Big rad
Electric fans on a switch
6 point roll cage with door bars ( i have 2 extra door bars to make a cross that haven’t been welded in yet to confirm to some comp rules )
Bride seats
Bride seat rails
Tom’s harnesses
Battery in boot
Tubbed arches
The kit is a bit mix and match, RB spoiler, BN Sports rear bumper/front bumper and skirts, with origin front and rear over fenders.
Veilside exhaust system (very nice, has silencers so it’s not stupid loud on idle)
Braided brake lines from the master cylinder
Rota grid drifts 17x9
Front mount inter cooler
Abs delete
No rot underneath car was under sealed when imported and is going to be re done before new owner will send pictures before and after, undersealed the car when Previous owner imported it.
Bad bits -
This car is rough around the edges because it’s been used :)
£20,000
As is
|