BMW 316i e30 2.5 engine

Description:

1990 BMW 316i e30 rebuilt project, lots to list probably forgotten some bits, just seeing what's about, would swap if something takes my fancy

Front subframe:
- E46 purple tag rack
- bmconversions rack spacers
- new inner tie rods e36
- new outer tie rods e36
- new e36 lower arms
- SRS cooper bushes
- new front wheel bearings
- new top mounts
- new coilovers
- custom steering column

Brake System:
- New front discs e36 323
- new front pads e36 323
- e36 calipers front e36 323
- front braided brake hoses
- E90 brake servo
- new brake fluid dot 4
- new copper lines front and rear
- rear e36 calipers e36 318ti
- new rear discs e36
- new rear pads e36
- new hand brake cables
- new hand brake shows
- new hand brake fitting kit
Rear subframe:
- New rear wheel bearings
- new rear coilover suspension
- new rear top mounts
- Polybushed, reinforced and sandblasted rear subframe
- Polybushed, reinforced and sandblasted rear trailing arms
- e36 small case drive shafts
- e36 open diff with new gear oil
Transmission:
- serviced E36 getrag gearbox
- new e36 slave cylinder with new brake fluid
- E36 prop with new e30 centre bearing
- short shifter
Engine:
- M54b25 from an e46
- new disa valve
- new inlet gasket
- Oil changed
- new spark plugs
- new aux belt
- custom BM conversion power steering lines
- new e34 engine mounts
- e38 sump and dip stick holder
- hack engineering adapter harness
-e46 throttle pedal mounted to the car and plugged into the adapter harness
- ews deleted and remapped ECU
- new e36 radiator
Extras:
- The car under went full rust removal and restoration before I started building the car myself. This was done by a small local, family run engineering firm with a good reputation and it was completed to a very high standard. I can provide pics of anything upon request.
-heater motor replaced while the engine was out and for easy access
- Full staininless steel exhaust system and manifolds with manifold gaskets
- E60 alloy wheels balanced with good condition tyres.
- Clocks modified with a switch to read accurately
- 12 months MOT

In all honesty just looking mainly to see what it's worth, also if the right s body comes along I'm sure I wouldn't be able to resist